reported earlier Disperse under fire issue

[Ramses823]

I notice that disperse under fire isn't working for AI for some reason, this is a command I use often but now it isn't working; basically I have ground units I want to stay in a particular position but once they are fired on now they are moving around heck even my ground crew that I have at the airfield changes position once the firing starts although they are nowhere near any combat action very strange behavior.  this is happening on the Afghanistan map I'm not sure if its happening on any other maps. I tried to upload the track file but even after letting the mission run for less than two minutes it says it's too big to upload.

Edited March 28 by Ramses823

[Flappie]

This was reported before. I'll bump the internal report right away.

[Nealius]

Yes this is causing a lot of gameplay issues, especially when embark tasking is required. I always set them to hold position behind cover with "disperse under fire" is off. Despite being behind solid cover, they start dispersing and a few of the infantry units clip into walls or buildings they shouldn't have been able to pass through at all. Then when a helo comes in to embark them, the embarkation process gets stuck because the dumb AI that isn't respecting "disperse under fire off" disperses and gets stuck inside a wall or building, running around in circles for ten minutes.

[buur]

This is a really annoying bug! Fight against tank columns get stupid with this bug.